![This is why you should not adapt single perimeter wall thickness by changing the extrusion / flow rate This is why you should not adapt single perimeter wall thickness by changing the extrusion / flow rate](https://reprap.org/forum/thumbcache/265/318/28c/ad8/97a/cd8/876/b57/371/ab0/7b_800x400.png)
This is why you should not adapt single perimeter wall thickness by changing the extrusion / flow rate
![An illustration of the raster angle and extrusion width from Simplify3D... | Download Scientific Diagram An illustration of the raster angle and extrusion width from Simplify3D... | Download Scientific Diagram](https://www.researchgate.net/publication/334268685/figure/fig1/AS:777476938682368@1562376355583/An-illustration-of-the-raster-angle-and-extrusion-width-from-Simplify3D-toolpaths-The_Q320.jpg)
An illustration of the raster angle and extrusion width from Simplify3D... | Download Scientific Diagram
![slicing - Slicer line width vs. extrusion multiplier for layer adhesion? - 3D Printing Stack Exchange slicing - Slicer line width vs. extrusion multiplier for layer adhesion? - 3D Printing Stack Exchange](https://i.stack.imgur.com/sSvon.jpg)
slicing - Slicer line width vs. extrusion multiplier for layer adhesion? - 3D Printing Stack Exchange
![Perimeter, Infill, and Flow Rate issues. (Page 1) — Help/Repair/Maintenance — SoliForum - 3D Printing Community Perimeter, Infill, and Flow Rate issues. (Page 1) — Help/Repair/Maintenance — SoliForum - 3D Printing Community](http://www.pdxmc.com/uploads/SD3/20130422_210834.jpg)